Fascinating! Here are some things that I notice about the ROM SIMM's pinout based on the picture:
- It's definitely programmable. The Am28F020 is a 2 megabit flash chip.
- The total capacity of the SIMM (assuming there aren't any chips on the back) is 1 megabyte, which would put it at the size of most Quadra ROMs, and a handful of later 030 machines as well.
- The thick trace running across the top goes to pin 1 on the chips, which is "VPP". You have to put a high voltage on this pin in order to erase/reprogram the chips. I suspect that resistor R1 is pulling it down to ground for normal operation. I wonder if VPP is also brought out to one of the pins on the SIMM connector...
- It kind of looks like they might have picked SIMM pin 13 for this. If you look at pin 13 in the picture, it has a really fat trace matching that thickness that goes directly to a via.
- Chip pin 31 (write enable) which is also needed for erasing/reprogramming is also hooked up on all 4 chips, so I suspect it's brought out to one of the SIMM pins. I'd be curious to know what pin Apple actually officially used for WE. I don't think it matches the pin I picked on my programmable ROM SIMM that became the ROM-inator, because I used SIMM pin 13 (which appears to be VPP on this SIMM). Probably doesn't matter for the purposes of reading out the contents though.
- If I had to guess, I would probably say SIMM pin 3, which is one of the unused address pins. It looks like if you go straight up from pin 3, there's a via near the top of the board, and that trace goes to the WE pin on all the chips. I'll bet on the back of the board there's a trace that goes straight up from pin 3 to that via.
- I checked a few of the data pins and it seems to match the normal Apple ROM SIMM pinout.
It's very likely that my ROM SIMM programmer (which isn't made by me or bigmessowires anymore) is capable of reading the current contents of this SIMM. Unfortunately, I couldn't make more if I tried right now, due to the global chip shortage. There are several forum members who bought one from me originally. There might be some SIMM programmers floating around in the UK...maybe someone who has one will see this thread. Desoldering the flash chips would work too, but the programmer would make it massively easier.
I like the idea of trying to boot an SE/30 or II series Mac with it. Some (but not all) of the newer Quadra ROMs are also capable of booting the older II series machines and SE/30. So if you can get it booted, you could read out the contents with CopyRoms or a similar utility.