Rajel
Well-known member
Yeah, Makerbot was an open design too... at first.
Micro Center carries a Replicator 2X clone for $700 that basically spanks the official model. I've seen prints come off that I can't touch with the Rep2 after it's been freshly leveled, cleaned, and tuned.
Smaller buildplate though. I do like the build area I get with the Rep2, although I'm itching for a bit more. I've got some large designs I'd love to run off in one piece.
JohnnyA: Had a crazy busy weekend and working late tonight, I'll get the single prints started asap, likely tomorrow evening.
Micro Center carries a Replicator 2X clone for $700 that basically spanks the official model. I've seen prints come off that I can't touch with the Rep2 after it's been freshly leveled, cleaned, and tuned.
Smaller buildplate though. I do like the build area I get with the Rep2, although I'm itching for a bit more. I've got some large designs I'd love to run off in one piece.
JohnnyA: Had a crazy busy weekend and working late tonight, I'll get the single prints started asap, likely tomorrow evening.