Feets! Where to get replacements?

[uniserver]

Hello, i was considering posting this in trading post but, i figured it would be good general info incase a googler comes across this thread.

I happen to have a IIcx that needs a set of 4 of the rubber feets,

did some google searches, didn't find anything.

 

[markyb86]

Not factory replacements but these might be good candidates?

http://www.amazon.com/Small-Clear-Cabinet-Furniture-Bumpers/dp/B005S1TJLC/ref=pd_cp_hi_0

144 pack for ~$14.

I'm picking this up soon.

 

[Trash80toHP_Mini]

If you buy the square ones they look more like the OEM deal and the thickness is about right.

If you sculpt them into rectangles they won't be the right size and they'll be beveled, but they'll look more stock . . .

. . . and then there's always the high heeled, platform feets option . . . }

 

[uniserver]

sure who is sellin heels for my " c " series MacII's ?

 

[uniserver]

"high heeled, platform feets option" isnt this a jt only exclusive?

they are not a real product you can buy etc….



i like to MOOD lighting lol haha. so funny.

 

[Trash80toHP_Mini]

Not a jt exclusive, innovation maybe. They practical feetsware, allowing MiniFeetsMacs to survive running on a carpeted surface. They're open toe source, production documention and everything!

 

[uniserver]

too funny. open toe-- Err Open Source… haha

 

[uniserver]

gosh a source for Stock Q700 Feets would be great…

 

[markyb86]

It could be possible to make a mold and cast new

 

[uniserver]

MiniQuadraFeetsMac™ - Thread

viewtopic.php?f=29&t=12478

I don't see in this thread how you even made those high heeled feets,

did you take some plastic from something else, and then just jam some lag bolts in the bottom?

 

[markyb86]

If you want to do it for the looks alone, it'd be/look better to use a much thinner "platform" to tie the feets together and then add the rubber pads. I used a one piece 3/4" MDF Platform with 3/4" MDF laminates (I had a lot of MDF scrap and cutoffs lying around) for the feets' "risers" for simplicity. They're meant to hold the Q700s on their "platforms" and the radius of the semicircular portion/width of their "tombstone" cross-section was determined by size of the holes I needed to tap for the 3/8" Hex Bolts selected for the leveling heels.

They be sawdust!

 

[uniserver]

heck you could make anything with a 3D printer.