smrieck511
Well-known member
Any favorites? Looking for something smaller of course and what is the recommended wattage for logic board work?
I have the same Hakko, my only complaint being occasionally it isn't able to keep the tip at temperate on joints with larger thermal mass. I may find one with a bigger wattage heater at some point.I went through two cheapo irons before settling on a Hakko FX-888D. Wish I’d just gone that way from the start. It’s not small, but was a total level up. If small is a must I’ve heard good things about the Pinecil.
I had some of these and they stopped working the second time I used them.WEP 938D hot tweezers for SMD caps
Man that thing looks like a beast. Cost?Also if you do any thru hole desoldering a S993a desoldering vacuum gun is a must.
View attachment 53192
I'm really satisfied with my Aixun T3A
+1 spent the money on that as my first iron.Hakko FX-888D