Hi
I recently purchased a BlueSCSI device. I have placed a system 7.5.5 image on a exFAT SD card and installed that in the BlueSCSI.
When I connect the BlueSCSI to the internal SCSI connector (was previously connected to the internal HDD), I am able to boot successfully.
However, when I connect the BlueSCSI inside an external HDD enclosure, and connect via an external SCSI cable, it does not boot.
- I am using SCSI 0 inside the SD card, and I have the external enclosure also set to id 0.
- I can see the BlueSCSI is getting power in the external enclosure as the red light is on.
- The external enclosure has a terminator mounted.
- The mac boots to the point where it has a question mark inside a disk symbol.
Any hints on how to get this working?
TIA
I recently purchased a BlueSCSI device. I have placed a system 7.5.5 image on a exFAT SD card and installed that in the BlueSCSI.
When I connect the BlueSCSI to the internal SCSI connector (was previously connected to the internal HDD), I am able to boot successfully.
However, when I connect the BlueSCSI inside an external HDD enclosure, and connect via an external SCSI cable, it does not boot.
- I am using SCSI 0 inside the SD card, and I have the external enclosure also set to id 0.
- I can see the BlueSCSI is getting power in the external enclosure as the red light is on.
- The external enclosure has a terminator mounted.
- The mac boots to the point where it has a question mark inside a disk symbol.
Any hints on how to get this working?
TIA