• Hello, Guest! Welcome back, and be sure to check out this post for more info about the recent service interruption and migration.

Network card hardware error...

cannfoddr

Well-known member
Just fired up my recapped SE/30 and put the network card back in.  I found some diagnostics on the HD and fired these up and am getting an address error from the Hardware diagnostics.  Card is using the dynaport driver but its a Shiva Access-T 



The drivers seem to load and the led flashes.  I've cabled it up to a cat 5 connection and the light goes solid so I think its working!

IMG_1049.jpg

Unfortunately the disk image I am booting from does not have TCP loaded so I am going to wait until the BMOW ROM is installed and RASCSI is working to build a new image with TCP and do some further testing.

 
Top