Just fired up my recapped SE/30 and put the network card back in. I found some diagnostics on the HD and fired these up and am getting an address error from the Hardware diagnostics. Card is using the dynaport driver but its a Shiva Access-T
The drivers seem to load and the led flashes. I've cabled it up to a cat 5 connection and the light goes solid so I think its working!
Unfortunately the disk image I am booting from does not have TCP loaded so I am going to wait until the BMOW ROM is installed and RASCSI is working to build a new image with TCP and do some further testing.
The drivers seem to load and the led flashes. I've cabled it up to a cat 5 connection and the light goes solid so I think its working!
Unfortunately the disk image I am booting from does not have TCP loaded so I am going to wait until the BMOW ROM is installed and RASCSI is working to build a new image with TCP and do some further testing.
