egrath
Well-known member
Hi,
as most of clips which holds the 30-pin SIMMs in place brake off by just looking at them, this has also happened to the previous owner of the Mac II logic board i'm currently working on.
Has anyone a good working fix on how to secure the SIMMs in place when these tiny nibbles broke away? I found a 3D printed solution but don't know if they fit the II sockets as the guy who made it did this for his SE/30:
Before i print them out, anyone already used these on a II?
Best regards,
Egon
as most of clips which holds the 30-pin SIMMs in place brake off by just looking at them, this has also happened to the previous owner of the Mac II logic board i'm currently working on.
Has anyone a good working fix on how to secure the SIMMs in place when these tiny nibbles broke away? I found a 3D printed solution but don't know if they fit the II sockets as the guy who made it did this for his SE/30:
Printables
www.printables.com
Before i print them out, anyone already used these on a II?
Best regards,
Egon