Howdy All.
Like the topic says, I had some pads that lifted when I was reseating U26 on an LCIII. I've attached a picture to show which chip I'm talking about. The traces are the ones at the bottom of the chip closet to the RAM slot.
I can't quite see where the traces go for the two pads that have lifted, and I was hoping someone might be more familiar with the board layout and can point me to the right direction as to where I could run a wire off the pins of the RAM chips.
Like the topic says, I had some pads that lifted when I was reseating U26 on an LCIII. I've attached a picture to show which chip I'm talking about. The traces are the ones at the bottom of the chip closet to the RAM slot.
I can't quite see where the traces go for the two pads that have lifted, and I was hoping someone might be more familiar with the board layout and can point me to the right direction as to where I could run a wire off the pins of the RAM chips.
