It’s been quite a time in quarantine....fixed up a IIfx, Color Classic, SE/30, etc...
recapped my backlit model but can not get the floppy drive to work, it crashes the system. I have a second backlit motherboard I’m ready to recap but notice that Q4 has a missing pad....looking at the schematics it appears that Q4 was for power for external video, is this part necessary to replace? If so where can I run a jumper wire?
This part was missing on the board and when I went to clean up the pads I noticed that the pad was missing. How would this have been burned off?
thanks for any advice!
thomas
recapped my backlit model but can not get the floppy drive to work, it crashes the system. I have a second backlit motherboard I’m ready to recap but notice that Q4 has a missing pad....looking at the schematics it appears that Q4 was for power for external video, is this part necessary to replace? If so where can I run a jumper wire?
This part was missing on the board and when I went to clean up the pads I noticed that the pad was missing. How would this have been burned off?
thanks for any advice!
thomas