"Dumping" Protected GALs - Any Tricks?

[SuperSVGA]

If you feel like sharing the schematic once it's complete I wouldn't mind staring at it for a few minutes and making a wild guess what the registered one might do.

Yep, I'll upload it once I stop being stupid and getting turned around halfway though.

Here's what the current progress on the board itself looks like:

Along with the original scan:

There's a lot more going on in the inner layers than I anticipated, so it's going to take a bit to get it fully complete, but I should be able to at least get all the GAL connections mapped out.

you might want to consider using one of those "bitbang it with an arduino" methods to at least get it

Do you have a link to one of these? All I've been able to find so far is one that uses a custom PCB/shield, though I guess I could breadboard it if I was confident in the wiring.

 

[luRaichu]

Matthias Heinrichs / Galdurino · GitLab

GitLab.com

gitlab.com

 

[croissantking]

You can get around the security fuse on a lot of GAL16V8 and 20V8s by messing with the programming voltage.

You have to apply a voltage to the programming pin just at the right time before VCC to the chip gets applied and then read it like you normally would.
The problem here is that the timing seems to be important so you’ll spend a lot of time with trial and error. Another unknown factor is the voltage that you have to apply. This is not necessarily the actual programming voltage of the chip but rather a seemingly random value between 7V and 20V depending on the chip.
Make sure to not directly connect the external voltage source or you’ll instantly fry the GAL but instead use a 4.7k resistor in series.

I’ve been messing around with the GALs on a Micron Xceed SE/306-48 according to your notes but haven’t got any to reveal their contents yet. I’m using a T48. Unfortunately, my bench PSU only goes up to 15.5V so this could be a bit of a show stopper.
I just wanted to check:

- that the programming pin is indeed pin#1?
- how long before hitting read (on average) were you applying voltage to the programming pin? Are we talking a few seconds, or a fraction of a second?