Internal SCSI CDs were customarily SCSI ID3, the Mac/Boot Drive was ID0. Was there an Apple convention for internal SCSI Zip Drives?
6x00 SCSI Zip Drives - What SCSI ID did Apple assign them?
- Thread starter Trash80toHP_Mini
- Start date
Agreed, typically Apple used SCSI ID 3 for internal CD ROM Drives.
I thought they'd switched to IDE Zips in the Beige Boxen?
Beige G3s came with both at various times for some reason.
Edit - duh me, because the IDE was screwed up on early Beige G3s. Two busses, but each would only take one device, so that's hard disk, and CD-ROM.
Later versions of the Beige G3 had better IDE that could work with two devices on one bus, so they might have switched over then.
THX!
MY External Zip Drives are well and truly buried. IIRC, they had a binary SCSI ID select switch? What were the 2 IDs?
edit: internal drives addressed almost the full range of available IDs on the Mac
www.pctechguide.com
MY External Zip Drives are well and truly buried. IIRC, they had a binary SCSI ID select switch? What were the 2 IDs?
edit: internal drives addressed almost the full range of available IDs on the Mac
SCSI Internal Configuration
Before mounting the device, you’ll need to configure it via the jumper switch located on the rear of the drive. SCSI ID setting: The three leftmost jumpers are used to configure the drive’s SCSI ID number. This can be assigned a value of 0 through 7. Usually, 7 is reserved for the SCSI host...
Tried that already, searched both pics and hits, futile waste of time as IDE and Internals muddy the mix. I've started asking general questions of the gang here. Thinking would be that whatever something doesn't pop up in on site search quickly, it's info to be circulated?
ISTR it was ID5 & ID6?
ISTR it was ID5 & ID6?
4 seconds on Google :
Please don't ask questions you can Google in less time.
Similar threads
