Here is a weird one:
I have a SCSI2SD 5.1 that I've been running my Quadra 700 off for a while. This works great. Before that, I had also run it from an ACARD IDE->SCSI bridge with CF adapter. It still works great.
I've moved the ACARD into an external SCSI enclosure that used to have a very noisy drive. The enclosure also works great with noisy drives, or with either of my two solid state SCSI solutions.
Except: I connect both at the same time (on different IDs) I get a flashing dialogue that says "Bluets & Granola bars". It shows up just before it would normally start loading extensions.
It doesn't matter which one is in the external enclosure and which is internal. It boots fine from either board, whether connected internally or externally, so long as they're not both connected at the same time.
Make it stop? Please?
I have a SCSI2SD 5.1 that I've been running my Quadra 700 off for a while. This works great. Before that, I had also run it from an ACARD IDE->SCSI bridge with CF adapter. It still works great.
I've moved the ACARD into an external SCSI enclosure that used to have a very noisy drive. The enclosure also works great with noisy drives, or with either of my two solid state SCSI solutions.
Except: I connect both at the same time (on different IDs) I get a flashing dialogue that says "Bluets & Granola bars". It shows up just before it would normally start loading extensions.
It doesn't matter which one is in the external enclosure and which is internal. It boots fine from either board, whether connected internally or externally, so long as they're not both connected at the same time.
Make it stop? Please?