Make sure that you have a CC-04 cable connecting your player to the modem port on your Mac. If the CC-04 cable is connected to the printer port, the program will prompt you and set communication via the printer port. If you are using the Macintosh PowerBook Model #170 and you are connected to the modem port of that computer, you must set the modem switch in the Control Panel to the "external" setting.
The Bar'n'Coder program is smart enough to determine the baud rate setting on your player and will adjust the software accordingly. However, please make sure your player is set to the following parameters:
Data Length = 8 bit
Stop Bit = 1 bit
Parity = No
These parameters can only be set on the LD-V8000 and LD-V4200 player. Refer to your player's Operating Instructions manual to review the procedure for setting communication parameters on your player.
These parameters are automatically set on the LD-V4400, CLD-V2600, CLD-V2400, and LD-V2200 players.