Macintosh IIsi PRAM problems ...

[franklyn]

I successfully repaired my Macintosh IIsi ...

IIsi fault ...

I have a IIsi that works before fine and now it take some time until the sound of dead sounds up. The motherboard looks good except for a little oxidation on the four 74ALS245 chips. I desoldered these all and cleaned everything up and checked connections and soldered on four new chips but the...

68kmla.org

... but I noticed that the computer has a problem with the PRAM, it always loses the settings it has made after switching it off and rarely but not.

What could be the error and where should I look?

 

[JC8080]

You're sure the coin cell battery is good, and the installation is sound, getting power to the right places?

 

[franklyn]

Yes I think so ...

I change the cell fro a new one (maybe a 3V cell is to low?)

 

[franklyn]

I took a closer look and it turns out that the pram stays active for a while after it is switched off but is lost overnight. I'm now going back to the original 3.6V battery...

 

[JC8080]

I took a closer look and it turns out that the pram stays active for a while after it is switched off but is lost overnight. I'm now going back to the original 3.6V battery...

I wonder how often modern 1/2 AA batteries need to be changed to be safe.

 

[robin-fo]

Is it possible that you have a short on your logic board which drains your battery?

 

[franklyn]

The same behavior also occurs with the original 3.6V battery. If the computer is connected to the mains but is switched off, everything seems to be fine. However, as soon as I switch off the mains and the computer is left for a while, the PRAM is erased. The battery is not discharged. The transistor Q7 cannot be defective, but what about the double diode?