Jump to content

Anyone attempted a portable display complete disassembly?


Recommended Posts

  • 5 months later...

I did it with a defective display (“lines”). You twist back the metal latches on the rear of the panel and separate the actual screen from the control board. Zebra pads in between. Putting the whole thing back is almost impossible, alignment and pressure level are factory job. Moreover, no benefit in regard to the dead lines, I would conclude they are consequence of failures in the active matrix panel. In a nutshell, just don’t do it.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...