Jump to content

Recommended Posts

Hello all,

I had turned on my Powerbook 540c yesterday and it worked fine (although I forgot to turn on the external CD Drive so it wouldn't boot initially, derp). After using it for a bit, I shut it down as normal, but later in the day (and today) it didn't turn on; it remains completely silent. :(

 

Am I correct in guessing that the power brick finally bit it, or could it be something else? I have heard of recapping the Blackbird's power supply, though it requires cracking open the enclosure...

 

Thank you!

Link to post
Share on other sites

You could try measuring the output voltage of the brick, however that wont tell you if its dipping under load. They usually all need to be recapped at this point. 

 

Edit: Also, Im not sure on the later Powerbooks, but on the 100 series, if theres a battery short it will cause issues. You could try removing the battery?

Edited by Johnnya101
Link to post
Share on other sites
1 minute ago, Johnnya101 said:

Also, Im not sure on the later Powerbooks, but on the 100 series, if theres a battery short it will cause issues. You could try removing the battery?

No worries on the battery pack, it's been removed for some time. I did fabricate a new PRAM battery and install some time ago using keyfob cells, but that doesn't seem to work regardless...

Link to post
Share on other sites

Zap the Power management chip. What you're describing can be a corruption in the power management system.

 

I forget the exact combo, but I know its documented.

 

When BlackBird power adapters die there is usually a loud pop, and/or, a flash of light (meaning a spark inside the adapter), and/or magic smoke. I've never seen one die quietly, and I've seen more than a few go over the years. If you didn't see any of those 3 things, it's unlikely your AC adapter is dead.

Link to post
Share on other sites

From this list I tried out the given sequence, but to no avail. Sadly, I do recall hearing a click or mild popping at one point unplugging/plugging in the power brick, but I had assumed (or hoped) it was the same sort of crackling noise you sometimes get when plugging in a more modern Macbook power supply into the power outlet.

 

Edit: I tried both the standard Power Management Reset (Cmd-Ctrl-Shift-Power) and the PB500 specific one (Cmd-Opt-Ctrl-Power), both to no avail. Should it chime at some point? I'm not sure what is supposed to happen.

Edited by Iesca
Link to post
Share on other sites
15 hours ago, Iesca said:

Would it be obviously loose? The metal outer ring on my adaptor seems pretty rigid. (Unlike, say, the one on the iBook G4...)

 

Yes. If the interface is damaged, it should be obvious. It is far more rare than a dead power brick these days. Actually. I'd say dead powerbricks is the norm, rather than a functional one these days. Out of 5 that I have plugged in, 1 mostly works, but will cut out if it gets too warm.

Link to post
Share on other sites

Another method that has worked well, which is kinda bizarre, is to put a golf pencil (for some reason it has to be a golf pencil, regular size pencil does not work as well) on either side, in a bench vice, and just keep twisting the vice tighter until it opens. For some reason, way the the pencils apply pressure, it will always fracture right along that indentation where the two pieces join and pops right open. It's the damndest thing, but people have proven it works more than a few times here. There should still be pics that show how.

Edited by Paralel
Link to post
Share on other sites

How interesting! I'll have to keep in mind.

However, between some earlier prying and gentle hammering on a box knife I was able to get the case open.

And I think we have found the problem... (see photo)

There is a shield underneath, any tips for removing that, or just have to unsolder it at the solder point?

20190123_111713_crop_scale.jpg

Link to post
Share on other sites

Happy to help! I will probably make a nicer diagram at some point in Illustrator, but in the meantime, the more of these power supplies we're able to save, the longer the blackbirds can be enjoyed!

For now, this particular cap from Nichicon seems to fit the bill for the one on mine that blew, but I'm probably going to just replace all of them (more than one is corroding underneath):

https://www.digikey.com/product-detail/en/UHW1J331MPD1TD/493-14598-1-ND/5818065

Screen Shot 2019-02-04 at 7.32.38 PM.png

Link to post
Share on other sites
  • 2 weeks later...

While I still plan on recapping the power supply, I just found on ebay the fabled Lind PB-5 car adaptor for Powerbook 500s!

Does anybody have any recommendations for a good AC to DC power converter for using car appliances indoors? US wall plugs, please!

574731492_ScreenShot2019-02-15at5_36_24PM.thumb.png.9cf0ba6674c25286e4e928b908070a69.png

Edited by Iesca
Link to post
Share on other sites
4 hours ago, Iesca said:

Also from Lind? In searching for one before I saw that they are still in business, but I had never heard of them prior to learning about the PB-5. (Also: you still have a Garmin??)

I have the parts that go with an old Garmin. I never throw out any power bricks, adapters, etc... (unless they are very common or I already have at least 2) you never know when they might come in handy.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...