Jump to content
Sign in to follow this  

Classic II over and under volt. Help

Recommended Posts

After a recap, I got the chime back, but still have screen issues. 

Checked the electromotive force, and I’m reading 13.51 and 4.47... and drifting lower & higher

Both are too far out of spec., and I’m asking for help on finding out where I should start with this one. 



When reading the -12 line, it holds -12 for about 30 seconds, than drops to zero, climbs to -1 or -2, than jumps to -12 again.

Any ideas?

This thing is everywhere 

Edited by jimjimx

Share this post

Link to post
Share on other sites

I think I’m going to start with the caps and see where the rails are at from there, and probe around to see what’s doing what..

Too bad I don’t have the parts here & now. I think I’ll double the order. 

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this