Jump to content
Sign in to follow this  
lowlytech

schematic question SE/30

Recommended Posts

Had a quick question on the last traces I have to repair on my se30.  On RP2 Pin 13 I get continuity on R41, but I do not on UD12 Pin 18.  On RP2 Pin 17 I get a beep on R42 but not on UC12 Pin 2.  Same thing with RP2 pin 18, I get a beep on R43 but nothing on UC12 pin 1.  The fact that I get a good connection between RP2 positions and the resistors on the back of the board, where could the break be?  Inside the boards layers?  Should I go ahead and run wires from the RP2 pins to UC/UD pins even though the resistors are showing good continuity?   

Untitled.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×