Jump to content

Need Testing Help with Mac External 400K/800K Drive

Recommended Posts

If you have a multimeter and a Macintosh External 400K or 800K floppy drive (models M0130 or M0131), I could use your help with a quick test. Put your meter in continuity check mode (where it beeps if there's a short circuit), and test for continuity between pin 9 of the drive's connector and any other pin. See the photo for the location of pin 9.


You need to make sure your multimeter probes are only touching one pin at a time, and aren't touching the metal shield around the pins, in order to avoid false positives on the test.


Hopefully pin 9 is not connected to anything. But I'm a bit suspicious it may be connected internally to pin 7 or 8, or possibly others. I don't have either of these drives, so I can't do the check myself. This is for exploring some crazy daisy-chain ideas for the Floppy Emu.


Thank you!




Share this post

Link to post
Share on other sites

Well, I was going to do that, but apparently I put it someplace VERY safe, and can’t find it.... But I found my SD to 40 pin ide card, that I need for the iBook G4....

I’ll continue to look.............



Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now