Search the Community
Showing results for tags 'diy'.
Found 2 results
Hello, I figured I would start a topic for my custom case/ATX conversion of my Quadra 650! I got the logic board from just.in.time for $5 dollars, in untested condition. I actually found the matching connector for the power connector on Mouser! I ordered that, and I used clip leads for a first test, set up for hard power. I connected a speaker, and applied power. The board chimed, and it booted to the question mark. Yay! The board was good. Then, I connected an external scsi hard drive, which was read and it booted. Now, I'm going to assemble the proper cable so I don't have to use clip leads. I'll post some pictures of it after it is assembled, and then I will work on the soft power circuit. After I convert it to ATX, I will design a case and cut it on my laser cutter.
Hello all, I wanted to hear your thoughts on this; I recently acquired a recapped SE/30 (which as of this past weekend is now using a CF card for solid state storage and super-fast startup!) The machine is beautiful, but what has proven a mixed blessing is the damage to the plastic of the front casing that occurred during shipping (I say this because I ended up getting the machine for free via UPS shipping insurance due to the damage and an unseated ROM SIMM which caused SimasiMac) To cut to the chase: Has anyone had any experience repaired cracked or broken off plastic on these compact macs? My plan is to reattach a piece, fill in the cracks (pictures below) with some kind of material), then sand it down so it is flush with the rest of the casing. Here's a link for a two-step plastic I found, if you have any suggestions or alternative solutions, I'm all ears. http://www.plast-aid.com/ // mdent23