Search the Community
Showing results for tags '540c'.
Found 4 results
Hello all, I had turned on my Powerbook 540c yesterday and it worked fine (although I forgot to turn on the external CD Drive so it wouldn't boot initially, derp). After using it for a bit, I shut it down as normal, but later in the day (and today) it didn't turn on; it remains completely silent. Am I correct in guessing that the power brick finally bit it, or could it be something else? I have heard of recapping the Blackbird's power supply, though it requires cracking open the enclosure... Thank you!
Hi all, I've come across a PB 540c going for the equivalent of USD60 (+ 10 for shipping). It has two dead batteries and no power-supply. It is a nice machine and the price is not at all bad. The seller has posted pictures of it working by means of a universal power supply. It seems that one cannot get batteries rebuilt for the 500-series PB. I have a few questions: 1. Will any PB 500-series power supply work or do I need one specific for the PB 540c? 2. How often do power supplies turn up on eBay etc? 3. Are there known problems with these power-supplies and can they switch voltage (110V - 240V)? 4. If anyone has one that they are willing to part with, would you PM me please? Thanks very much aa
Hopefully, this would come in handy for anyone curious about the PCMCIA module made for the PowerBook 500 series. I've posted as many pictures from various angles of the board assembly and parts (in case anyone has interest in planning modifications and how much space is inside the module) as I don't intend to open this up very often. If at all. There are three hex screws, one plastic tab, and a sticker holding my Rev C module together. I didn't have a hex bit of the correct size, but a Torx T6 proved a snug fit that allowed me to remove the screws. When I depressed the plastic tab back a small distance, I was able to carefully lift and separate the pieces only slightly, hinging at the sticker in the back. Some patient "working" back and forth allowed me to carefully separate the sticker from one of the pieces, and the unit was opened. I worked the board assembly from the back to the front to lift it from the bottom molding. The module ejection mechanism is separate from the board, and is a fixture on the bottom molding - it may be difficult to replace if it becomes damaged. Here is the bottom side of the board assembly. All pieces, angled, minus screws. Left side top (from front of module). Right side top (from front of module). Left side bottom (from front of module). Right side bottom (from front of module). Overview of bottom of board. All pieces of the module. Front hinging doors of the module. There is one stretched "rubber band" that acts to spring the doors back to resting position. If this part breaks someday, you could probably just install a rubber band to replace it...I'm actually surprised this one hasn't dry-rotted, yet. Or hack another spring assembly to your fancy. Okay. Just let me know when you make USB and cardbus possible for the 500 series.
Ran into an issue where my power adapter for my Powerbook 540c was outputting 16v on one pin, but only 2.xv on the other pin so my 540c would no longer start up. Took the PA apart(it's epoxied together) and discovered 6 capacitors. 2x 330uf - 25v, 2x 100uf 200v, and 2x 100uf 25v. The part numbers can bee seen in the picture. While the capacitors didn't look bad, I knew they were 20 some years old and it was time to swap em out. Sure enough, as soon as I soldered in the new caps I got 16v back on both pins and my Powerbook 540c is happy again!