Question about the Macintosh Portable
- Thread starter Froggy814
- Start date
I found out that the
DS3691V
chip has a couple pins that hove become disconnected. Is it fixable because the pins are almost impossible to see the break, and would i be able to reflow the solder with a soldering iron? Also if it needs replacing what would I replace it with because I cant find a replacement chip except for at quext components which I dont want to spend more then I have to, I would also like to buy it from mouser or digikey if I could. Thanks!
Yes you can reflow the solder - I advise using a little flux to ensure everything behaves.
X = external, I = internal
The page numbers of the schematic that the signal connects to. For example, DISP_BLANK* is also present on pages 2, 12, and 18.
Ah okay! Thank you very much! I just got my portable working and I am waiting to put it back together until I can do the 2 diode mods, (waiting for shipping is a bear.) So I was just thinking of trying to take a portable video adapter and adapting it to the display connector on the inside. For replacing the display when all of the transistors wear out on the internal display. Which even though it might be 10-20 years, I want to be prepared and have everything tested before then.
