Hi All
Just picked up my first Lisa and started to inspect it.
The large Rifa X C2 cap has got small cracks in it so I'll be replacing that before it explodes (been there before on a ][+, don't fancy it again...)
There's 2 smaller 2200pF Rifa Y caps at C3 and C4, are these usually good to replace too?
I noticed on the inside of the metal PSU case there's a dark heat mark next to C18 which is a large 16V 2200µF electrolytic - is that normal or should I be looking to replace that too before it dries out?
Any other advise on what to check for would be great!
Just picked up my first Lisa and started to inspect it.
The large Rifa X C2 cap has got small cracks in it so I'll be replacing that before it explodes (been there before on a ][+, don't fancy it again...)
There's 2 smaller 2200pF Rifa Y caps at C3 and C4, are these usually good to replace too?
I noticed on the inside of the metal PSU case there's a dark heat mark next to C18 which is a large 16V 2200µF electrolytic - is that normal or should I be looking to replace that too before it dries out?
Any other advise on what to check for would be great!
Last edited by a moderator:
