G4 Quicksilver PSU repair

[davidg5678]

Hi all! Has anyone here worked on the SMPS for a G4 Quicksilver? I've got one on the bench that seems to be failing to start up. It sort of pulses on and then off and is probably entering a protection mode. I've got a general book on SMPS repair that I'm reading, and will soon use it to apply more general diagnostics to the thing. If anyone is inspired to do something similar, you should know that safety precautions are needed to do this without getting hurt. I think it's extremely likely the capacitors in the secondary side have gone bad...

Anyhow, if anyone here has fixed one of these and has some anecdotal knowledge to share, that would be very helpful! There's not much about fixing these guys on the web. I know I could do an easy ATX mod, but that's not something I'm interested in right now. Otherwise, I'll try to keep folks here updated as I tinker and hopefully fix the PSU myself!

 

[herd]

I think it's extremely likely the capacitors in the secondary side have gone bad..

I agree. I've repaired several by replacing caps. Good luck and let us know how it goes!

 

[davidg5678]

I've started working on this PSU again! A few notes, while work is still in-progress:

The PSU is really dense and cramped inside. I needed to remove all of the major power transistors and the heatsinks holding them in place. I didn't want to disassemble the PSU so substantially, but I have no regrets about doing so now. Servicing this power supply would have otherwise been miserable/impossible.

The twin daugterboards' capacitors on the primary stage all had terrible ESR and needed to be replaced. The daughterboard capacitors on the secondary stage were amazingly all in great shape. I'm planning to replace them all anyway, because I don't have any intention of tearing this PSU apart again any time soon.

The major bulk filtering capacitors on the primary side were both in good shape, and I'm going to leave them alone. They are nicer Rubycon parts, in contrast to the crummy smaller green Lelon caps scattered throughout the PSU.

I still have to finish recapping the PSU, which I hope to get to later this week. But now that I know definitively that several capacitors failed, I have hopes about getting this working again! Fingers crossed there are not any other mystery faults.

Stay tuned for the results of the repair, several photos, and a detailed list of all the electrolytic capacitors inside this unit. I have scoured the internet far and wide, and there just doesn't seem to be much info out there yet about Quicksilver PSUs.