krishnadraws
Well-known member
I have a very corroded RF shield for my Mac SE/30. I would like to know what material it is made of so that I can use the old one as a template to make the new one. Any help would be greatly appreciated. Thanks!
-
Updated 2023-07-12: Hello, Guest! Welcome back, and be sure to check out this follow-up post about our outage a week or so ago.
Material to make replacement RF shielding for Mac SE/30?
- Thread starter krishnadraws
- Start date
mousehouse
Well-known member
Did anyone have a go at recreating the shields?
There seems to be a good template here : https://tinkerdifferent.com/threads...ompact-macs-128k-512k-plus-se-and-se-30.3039/
There seems to be a good template here : https://tinkerdifferent.com/threads...ompact-macs-128k-512k-plus-se-and-se-30.3039/
s_pupp
Well-known member
Using a cheap micrometer from Northern Tools: My SE shield consists of a 7mil aluminum sheet (approx 1/128", 0.18mm) covered with a 10mil (1/100", 0.254mm) plastic sheet. Either an adhesive backed plastic shield or a sheet of plastic sprayed with contact cement could be adhered to the aluminum.
The closest I can find on Amazon is a 5mil aluminum sheet, and 2mil adhesive vinyl sheeting.
The plastic sheeting of the SE shield I measured extends beyond the aluminum by a few inches, so, unlike an SE/30 shield, a replacement plastic sheet for the SE would need to be rigid, not flexible like the 2mil sheeting I linked to. Alternatively, I believe an SE/30 shield should work (please correct me if I'm wrong).
The closest I can find on Amazon is a 5mil aluminum sheet, and 2mil adhesive vinyl sheeting.
The plastic sheeting of the SE shield I measured extends beyond the aluminum by a few inches, so, unlike an SE/30 shield, a replacement plastic sheet for the SE would need to be rigid, not flexible like the 2mil sheeting I linked to. Alternatively, I believe an SE/30 shield should work (please correct me if I'm wrong).
