Bill.Canfield
New member
...or someone who know's how to repair the SCSI interface IC.
I have acquired a color classic about a year ago. Since then, I have only been able to boot into it once. The CC will not recognize the internal hard drive.
I've tried swapping with another 80MB SCSI HD, and booted with the install disk, but the CC wont recognize the HD. I tried terminating the SCSI port on the rear of the machine... which seemed to allow the CC to recognize the HD. The CC was able to recognize the HD and it allowed me to begin installing System 7, but after about an hour the machine (I haven't been able to recreate this scenario since).
I've replaced the PRAM battery, which didn't help my situation at all... and I have also tried blowing out the logic board too.
After all of this, I believe that my SCSI interface chip is bad... but I don't have any experience soldering on a double sided PCB.
Does anybody have any tips on how I could/should remedy this situation?
I have acquired a color classic about a year ago. Since then, I have only been able to boot into it once. The CC will not recognize the internal hard drive.
I've tried swapping with another 80MB SCSI HD, and booted with the install disk, but the CC wont recognize the HD. I tried terminating the SCSI port on the rear of the machine... which seemed to allow the CC to recognize the HD. The CC was able to recognize the HD and it allowed me to begin installing System 7, but after about an hour the machine (I haven't been able to recreate this scenario since).
I've replaced the PRAM battery, which didn't help my situation at all... and I have also tried blowing out the logic board too.
After all of this, I believe that my SCSI interface chip is bad... but I don't have any experience soldering on a double sided PCB.
Does anybody have any tips on how I could/should remedy this situation?