Mk.558
Well-known member
I've seen a few posting of some smart folks who dive into DeclROMs and other stuff involving the startup boot sequence.
This gets me interested because in Gamba's instructions for installing 8.1 on 68030 machines, and I'm not sure if I found an error not. Perhaps we can shed some light on it.
In the instructions for 8.0, one of the required steps is to edit the gusd resource at the 000010 offset. In that position, I would do the following (for a IIci):
However in 8.1, it says to do the same steps, but :
I've been fighting 8.1 on this machine for almost the entire day, and I'm not sure which one is correct. Shouldn't it be
for the 8.1 as well? I'm going to try both. It only takes 10 minutes to decompress a vanilla 8.0 install :/
edit: paging @eharmon
This gets me interested because in Gamba's instructions for installing 8.1 on 68030 machines, and I'm not sure if I found an error not. Perhaps we can shed some light on it.
In the instructions for 8.0, one of the required steps is to edit the gusd resource at the 000010 offset. In that position, I would do the following (for a IIci):
Code:
0016 0006 < old
000B 0005 < new
However in 8.1, it says to do the same steps, but :
Code:
0016 0006 < old
000B 0006 < new
I've been fighting 8.1 on this machine for almost the entire day, and I'm not sure which one is correct. Shouldn't it be
Code:
0005
edit: paging @eharmon
Last edited: