daanvdl
Well-known member
HI all,
Because i had some small issue with my color classic's analog board (very little, but fibrating screen) i replaced all the capacitors..
(hell of a job, but, my little mac deserve this of course).
But, after replacing all the caps, the mac doesn't start anymore.
When i turned it on, i hear a few clicks, and then is stops.
When i remove the logicboard, it keeps clicking (nearby the CRT)
I checked the polarity and solderjoints and capacitor values, but i can not find any mistake.
What is the best way to troubleshoot this, without replacing (again) all the caps?
Greetings,
Daan
Because i had some small issue with my color classic's analog board (very little, but fibrating screen) i replaced all the capacitors..
(hell of a job, but, my little mac deserve this of course).
But, after replacing all the caps, the mac doesn't start anymore.
When i turned it on, i hear a few clicks, and then is stops.
When i remove the logicboard, it keeps clicking (nearby the CRT)
I checked the polarity and solderjoints and capacitor values, but i can not find any mistake.
What is the best way to troubleshoot this, without replacing (again) all the caps?
Greetings,
Daan
Last edited by a moderator: