senrew
Well-known member
Decided to try out the monitors I got in a pickup last week. This m7649 seems to work perfectly well. Cosmetically, it's got some scratches, but I can barely see them when the thing is on.
The only problem I have, is that the leg slides all the way to the furthest extension when the monitor is stood upright. I disassembled it and took a look. I couldn't figure out exactly what was wrong but i think I've figured it out.
(I think?) the tensioner springs that hold the hinge are supposed to be held with some kind of little clip that seems to have been broken off as in the picture below.
Is there any way around this? The monitor sits at an almost flat angle with the leg extended all the way back and it's just unusable this way.
I thought maybe of sticking a couple screws into the gaps on the outside ring to prevent the hing from rotating and keep it at the full upright angle, but i can't find anything small enough to fit within the plastic housing that surrounds the spring assembly. When I tried the ones I could find, it "puffed out" the plastic just enough that the leg doesn't match up with the screw holes on the flange.
Any ideas or replacements to get this fixed? Would be nice to have a monitor to match my MDD.
The only problem I have, is that the leg slides all the way to the furthest extension when the monitor is stood upright. I disassembled it and took a look. I couldn't figure out exactly what was wrong but i think I've figured it out.
(I think?) the tensioner springs that hold the hinge are supposed to be held with some kind of little clip that seems to have been broken off as in the picture below.
Is there any way around this? The monitor sits at an almost flat angle with the leg extended all the way back and it's just unusable this way.
I thought maybe of sticking a couple screws into the gaps on the outside ring to prevent the hing from rotating and keep it at the full upright angle, but i can't find anything small enough to fit within the plastic housing that surrounds the spring assembly. When I tried the ones I could find, it "puffed out" the plastic just enough that the leg doesn't match up with the screw holes on the flange.
Any ideas or replacements to get this fixed? Would be nice to have a monitor to match my MDD.