Since 168-pin 5V ram is so scarce, and usually only found as FPM, I have received some KM44C16104BK-4 chips that should work great for the PowerMac 9600. I have one stick of 128MB FPM ram that I would have to sacrifice to trace the schematics but I would prefer not to do that if anyone happens...
I made some mock-ups of the platinum design theme for color LCD monitors. I can use Fusion to create a 3D model for an lcd panel so it matches.
I think using AUO M170ETN01.1 (SXGA) and a controller board with VGA, DB-15, DVI, and HDMI would be a good starting point. Anybody have better company...
I am trying to find the differences between the Sonnet/ZIF G4 1.0GHz models to figure out what makes some revisions B&W compatible.
The CPLD logic on Rev. A is LC4384V-35F256-5I:
I assume its the same for later revisions, but I don't have a picture to confirm that.
There is a chip...
The prongs that interface on the case panel chipped off and I'm not sure how to replace them or where to find a matching cable/prong or whole fan. Any ideas anyone?
I have a gigabit G4 (with sonnet 1.6ghz and SATA drives) and I have had a lot of trouble doing anything with 9.2.2. On this hard drive is the Universal 2013 Mac OS 9.2.2 install. It will not let me sleep the computer. On Mac OS X 10.5 it does fine and everything works.
Hi everybody,
I am wondering if the Sonnet Encore/ST G4 series can be overclocked similar to the Encore/MDX G4 Duet series as seen on http://macos9lives.com/smforum/index.php?topic=3523.0 by Knezzen and MacTron.
Here is a picture of the underside of the 1.6GHz card:
...the 1.7 GHz card...
The PowerBook 1400c lids are notorious for cracking at the hinge as you can see due to the screws on the underside. Is there a way to recreate or fix these? I was trying to redraw on CAD but my skills are not that good. Would 3D scanning be possible? If there is a solid way to remake these and...
I have a 16mb ram module for the 1400c and I cannot find any 24mb ram modules. Would it be possible to add the 4 needed chips and some kind of connection at C3 to change 16mb to 24mb? It looks like there are some online warehouses that have KM48C2100BS-L6 chips.
I have a IIci that has been recapped but does not work without a Diimo 50mHz accelerator. However, I want to put a carrera in it. An 040 accelerator won't work because it needs the original 030 to initially boot I believe. So...I took of the 68030FE25B processor and ordered a 68030FE33C...
I have a Mac Plus with a Graphics card that clips directly on the processor. I have been trying to get it to work for quite some time. Unfortunately the card comes with no markings. However, the processor is a 24-bit TI TMS34061FNL that looks like some RasterOps graphics cards might have used...