Hi all,
I was recently given a powerbook 5300cs that was working fine until one day it would not turn on at all when connected to power. As a fix, I tried 1.) desoldering and resoldering the power jack connector on the motherboard, as that is a common source of power problems, and 2.) replacing...
Hi all,
My 6100 has had two major issues recently:
1. When I try to start it up (still chimes and zuluscsi is installed with 7.5.5), the 6100 freezes at startup.
2. When I try to reset it, the 6100 enters a boot loop, where it will keep chiming and attempting to reboot but never goes past...
Thank you for the info: single IDE device per bus! I did not know that and it makes sense now why things weren't working.
Late reply, but wanted to give a solution for those with similar issues:
1. My internal SCSI ribbon cable was just bad. With a brand new ribbon, my internal ZuluSCSI...
Hello,
I had some issues connecting SCSI and IDE hard drives on my Powermac G3 Beige Desktop and wanted to get some feedback on possible solutions/causes.
My G3 contains an internal/external SCSI port and 2 different IDE ports. There is an IDE CD drive connected. Any time I try connecting a...
Okay, the solution was much simpler than I thought.
I just had to disable IPv6 in the network options in Tiger. So it was actually my router/modem configuration causing the freezing issues. My PowerBook (and now my other OS X 10.4 machines) work great now!
Thanks for the advice! I just ordered a replacement AirPort Extreme card so we'll see if that changes anything. If that doesn't work, I'll just keep the G4 as a OSX 10.3 machine, since ethernet still works on 10.3 for some weird reason.
Thank you! So I decided to reinstall Tiger 10.4.6, and after trying out different RAM configurations and still experiencing freezing, I decided to disable WiFi. After trying this out more times, the system is now always stable when AirPort is turned off. I guess whenever I had 10.3 installed...
Hi all, I need some help/advice on troubleshooting a Powerbook G4 15” Aluminum. I replaced the logic board and original hard drive when I got it, and since then, have noticed the following issues:
The G4 on OSX Tiger will always freeze after about 3 minutes, usually triggered by me opening an...
Thank you for the detailed advice!
I decided to switch out the AGP card I had with a PCI video card that supported VGA output. I still got the same issues, so at least I can rule out anything graphics card-related.
My second and third RAM slots are definitely wonky - I tried fitting in at...
Hi all, I wanted to ask for some troubleshooting advice because I am losing my mind trying to figure out what is wrong with a PowerMac G4 Quicksilver I recently got.
First, this G4 came with the original hard drive installed. I decided to flash a OS X 10.4 installer to a USB drive and...
Thank you everyone for the helpful advice! I ended up cleaning the riser contacts again and removed the Cache Simm card. Here’s the result:
it works! The question mark is just the fact that I don’t have a hard drive installed.
Hi everyone,
I recently got a Mac clone (Power Computing PowerCenter Pro 180 to be exact). There is a very strange issue I am encountering though: although the computer will sound the Mac chime on bootup, the video output will not display at all. I have tried using different monitors (both...