Jump to content

ochim

6502
  • Content Count

    3
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi Ferrix, thanks for tips, I will start to check those tomorrow. I believe it will take time from me to find the circuits from the board so I would really appreciate if you could point me where they are actually located.
  2. Thanks Macalle69 for giving me a good start. My analog board is international 240V. I did find that R53 and R54 were dead. About Q10 I am not sure if it is fine, as my dmm shows that b->e and e->b are shorted when tested in diode mode. C to emitter or base shows readings when minus lead is on c and OL when positive is on c. I will continue tomorrow to check if there is more broken components. Will you think that both fixes mentioned earlier in this thread would work for Q12 after i've founded and replaced all burned parts. Many thanks!
  3. Hi! I just bought macintosh+ and it also has blown fuse and Q12 EO122. Did I get it right that there's 2 ways yo fix it? 1. Change it to brx45 and add 1k 1/4w resistor into central pin like macalle69 did or 2. Change it to brx49 and replace R50 with 1k1-1k2 resistor Many thanks for your help! I have't checked if there's something else broken yet, just wanted to get this clear to me.
×
×
  • Create New...