I thought it was all working fine when I was testing it open, it would boot multiple disks and run fine. It turned out only because I had the floppy drive sitting upside down (to access contacts on the bottom of the board I was testing). Now that it is fully back together and sitting upright it will immediately kick back out most disks, a handful it will start trying to read, show the happy mac then panic and kick it out. A couple times it has crashed on error code 6 on the top row, FF on the bottom while booting.
Just turning it on the right side boots every disk fine and also formats disks fine. If after it has booted I turn it back upright it continues to read and format disks fine. Only boot seems to be a problem and not sure what to think about that.
Any ideas or seen something like this before?
Just turning it on the right side boots every disk fine and also formats disks fine. If after it has booted I turn it back upright it continues to read and format disks fine. Only boot seems to be a problem and not sure what to think about that.
Any ideas or seen something like this before?
