KEYSTRON MK2DS168E-60 16MB 30pin EDO for a Macintosh SE/30

gsprod

6502
Hello there,

I bought 8x16 MB EDO 30-pin memory sticks on Amazon, hoping to use them in my newly recapped Mac SE/30. However, when I install them (4 of them), I get a garbled screen. If I replace the first stick with a 1 MB stick, it works, but I only see 4 MB.
1. I know all the sticks need to be the same, so I suppose that explains why I get 4 MB. It seems to recognize my 16 MB sticks as 1 MB, I suppose.
2. I also know that, without a ROM change, the Mac SE/30 supports only 4 MB sticks.

I was hoping that without a ROM change it would recognize them as 4 MB until I replace the ROM (I’ve ordered a Garrett’s Workshop 8 MB ROM, but it will take a few weeks to arrive).

What do you think about these memory sticks? Should I wait for the new ROM, or should I send them back to Amazon because they will never work?

many thanks for your advice.

1772936854876.png
 
Send those back and get a refund. You don't want those.
Here is what you need for your SE/30.
They definitely work, I have 8 of them.
 
Last edited:
With a stock ROM only 8 MBs are seen, but I have a genuine Mac IIsi ROM SIMM (rare) in my SE/30 and that will recognize all of it. All 128 MBs are recognized with 32 bit addressing enabled. I also have another Mac SE/30 with a Rominator II that will recognize all with 32 bit addressing enabled. No errors but with the Mac IIsi, the memory test at boot is still enabled and takes almost 3 minutes before boot. I believe the Rominator II has the memory test disabled.
 
I run these same ram sticks without issue (with stock rom and mode32). Make sure they sit correctly in the slots (modern ram sticks are a bit thinner than the old ones). You might have gotten a bad stick or two so might be worth replacing through amazon to rule that out. Also, hardware issues on your motherboard could cause wierd things to happen as you go up in memory size.
 
Back
Top