I have a G4 MDD (single 1.25GHz FW400) that doesn't power on, which I'm sure means a dead PSU. I managed to find a spare but I don't know if the spare works. What is the pinout of the main motherboard power connector so I can probe it and see if it's putting out anything?
-
Hello MLAers! We've re-enabled auto-approval for accounts. If you are still waiting on account approval, please check this thread for more information.
G4 MDD main PSU connector pinout
- Thread starter EvieSigma
- Start date
Here ya' go.
http://atxg4.com/mdd.html
After the second power supply in my MDD died I finally just installed an ATX PS.
It's been working fine for a couple of years now.
http://atxg4.com/mdd.html
After the second power supply in my MDD died I finally just installed an ATX PS.
It's been working fine for a couple of years now.
Here's how I mounted mine. I used a couple of sheet metal screws through the top. (under the plastic of course.)
I first tried some double-sided foam tape but it wouldn't hold long term.
These pictures were taken before I was completely finished.
I also had to get an ATX extension cable to be able route the wires behind the optical drives.
The power cord routes out through the original plug hole in the back.
I also did have to invest in a Molex extraction tool. I tried other methods to remove the pins but finally gave in.
I think I paid about $16 for mine, I got it online somewhere.
I first tried some double-sided foam tape but it wouldn't hold long term.
These pictures were taken before I was completely finished.
I also had to get an ATX extension cable to be able route the wires behind the optical drives.
The power cord routes out through the original plug hole in the back.
I also did have to invest in a Molex extraction tool. I tried other methods to remove the pins but finally gave in.
I think I paid about $16 for mine, I got it online somewhere.
Last edited by a moderator:
Yeah, it was actually pretty simple after I surrendered and bought the Molex tool.
I hate having to buy a tool for a single job but really it was necessary.
On one of the pages about the ATX conversion I saw a warning about some systems having problems with deep sleep.
I haven't seen that or any issues with my system.
I suppose heat could be a problem if I ran the machine really hard but I only use the system every few days mostly for iTunes or browsing the web.
ATX extension cable so I could route the wires behind the optical drives like the original PS.
I have a full-length GF Ti4600. With a shorter card the extension may not have been necessary.
https://www.amazon.com/Cable-Matters-Motherboard-Power-Extension/dp/B01DV1Z66C/
None that I have found, and I looked pretty hard a few years back, otherwise I would have repaired mine then.
Reading around no one seems to have pin pointed a common failure mode, of if they have they haven't shared that info, unless something new has been posted in the last couple of years.
You can do the ATX mod to the QS too. But it's a bit more complicated.
http://atxg4.com/quicksilver.html
Last edited by a moderator:
Similar threads
