BlueSCSI v1 Hanging on Welcome to Macintosh (SE/30)

[smrieck511]

Curious what I might be doing wrong. Is this a jumper setting? Thanks for any help.

 

[3lectr1cPPC]

if it's getting that far then I'd guess it's more of a software configuration issue - try booting with extensions off, different system folder, version, reformat, etc.

 

[smrieck511]

if it's getting that far then I'd guess it's more of a software configuration issue - try booting with extensions off, different system folder, version, reformat, etc.

thanks yeah I will try some different system folders tomorrow.

 

[rjkucia]

Which System version are you using? And have you been able to boot from this System Folder previously (Specifically on this SE/30 with the Rominator)?

The Rominator requires that you adjust the System File with Resedit for some System versions.

 

[smrieck511]

I erased it and put 6.0.8 on it and it booted fine. Must've been the particular System Folder. Will try other system folders tonight.

 

[my03]

While i realize that i'm now necro-posting on an old thread, i had the same issue and also found the solution to it (for any future readers benefit).
You have to alter the "Gestald ID" (https://www.bigmessowires.com/mac-se30-with-upgraded-rom/) using a resource editor most likely.
I had to do it 15+ years ago when i swapped the scsi hdd out for an ide one (using a scsi/ide bridge) and 6+ years ago when i went scsi/cf and just recently once again when going BlueScsi/SD on the SE/30.

Just follow the instructions in the linked page and it will work out just fine