Search results

SMD packages don't sit completely flush to the board. If you use #32 bare wire there should be plenty of clearance.

All is not lost. It looks as if all the lifted pads are adjacent to via's. Run some thin through those holes and flow solder in from the other side. You should be able bend the wires outwards on the top and solder them to the DRAM pins. Only one of the holes seems visibly obstructed and can...

Joe is great people! I've had nothing but positive experiences dealing with him.

Docker *hates* me, but perhaps I'll give this application a try.

From my experience a battery is required in order to get video display.

I've had very poor results when attempting to remove caps with hot air. Solder that's been attacked by electrolyte does not conduct heat well. If you really want to go in that direction you'll want a pre-heater.

Yes, according to Joe's web page it's a fork of the HootSwitch project.

In general, do not NOT use metallic tools when tuning a slug inductor! You are seeing why!

Never thought about a 3d printed solution. Have Prusa, will travel.

Your log shows: [4961ms] DBG Waiting for USB enumeration to enter Card Reader mode. [6061ms] DBG Waiting for USB enumeration timed out after 1000ms. [6061ms] DBG -- Try increasing 'USBMassStorageWaitPeriod' in the bluescsi.ini Did you try what it suggested?

I suspect my Wifi access point (Archer AX5400) does not properly handle DDP packets. I am able to connect to an appletalk server with zuluscsi, but the connection does not persist over reboot and no zones are visible. Does this make sense in the context of improperly handled DDP?

I was able to resurrect two Lisa 2/5 machines with worse battery damage than yours. Soaking the CPU and backplane in vinegar overnight neutralized the battery grunge and they cleaned up quite well. Then it's a "simple matter" of finding and repairing any actual trace damage. May be a bit of...

I believe you need a crossover cable to wire the machines directly together.

Truer words were never spoken. My batting average on hot-air reflow (either direction) was miserable until I picked up an IR pre-heater. It is possible to work without one, but YMMV.

I ran your BMU0.JED through the conversion under dosbox. Let me know if this works? UPDATE: Here's another conversion from OPALJR.

The old DOS PALASM package had a utility called PALTOGAL.EXE that performs a direct translation of the JED file. Also something similar in the OPALJR package from the same period. Might be worth a try!

With appropriate AUI-to-10Base-T converters you may be able to use them for general localtalk to ethernet bridges.

Odd. I never saw a single problem with the one you sent me. I must lead a charmed life.

Voltage trim adjustment on some supplies (e.g. Astec and others) was done by adding / clipping resistors.

@Oliver_A - Where are you located?