Alan Gamma
Member
Recapped an SE/30 a while back and the machine itself seemed fine (although I didn't use it too much). I pulled it back out to mess around with 68k development, and have ran into an issue where, after a few minutes, the horizontal movement on the mouse is _extremely_ slow. I can move the mouse up and down just fine, but left and right _barely_ moves.
A restart doesn't fix it. Turning the machine off, waiting, and then turning it back on fixes the issue, temporarily. I'm guessing there's a trace cut somewhere that, when heated, is no longer making contact? Has anyone ever run into this before?
(Oh and I checked the inside of the mouse itself and didn't see any dirt on the rollers).
A restart doesn't fix it. Turning the machine off, waiting, and then turning it back on fixes the issue, temporarily. I'm guessing there's a trace cut somewhere that, when heated, is no longer making contact? Has anyone ever run into this before?
(Oh and I checked the inside of the mouse itself and didn't see any dirt on the rollers).