sbreit
Active member
Hi there!
Maybe one of you guys might have an idea about this:
I've installed OpenBSD 5.1 to my SE/30. Works OK except for the fact that I can't SSH to the box. Making SSH connections from the SE/30 to other machines on the other hand works just fine.
This is what the client sees:
and then fails.
The server will log the incoming connection and then after a few minutes prints "Timeout before authentication".
I already tried "Ciphers none" and "MACs hmac-md5-96" and also SSH protocol version 1 without much success. xx(
Any other hints?
Regards
Steffen
Maybe one of you guys might have an idea about this:
I've installed OpenBSD 5.1 to my SE/30. Works OK except for the fact that I can't SSH to the box. Making SSH connections from the SE/30 to other machines on the other hand works just fine.
This is what the client sees:
Code:
debug2: mac_setup: found hmac-md5-96
debug1: kex: server->client aes128-ctr hmac-md5-96 none
debug2: mac_setup: found hmac-md5-96
debug1: kex: client->server aes128-ctr hmac-md5-96 none
debug1: SSH2_MSG_KEX_DH_GEX_REQUEST(1024<1024<8192) sent
debug1: expecting SSH2_MSG_KEX_DH_GEX_GROUP
debug2: dh_gen_key: priv key bits set: 125/256
debug2: bits set: 520/1024
debug1: SSH2_MSG_KEX_DH_GEX_INIT sent
debug1: expecting SSH2_MSG_KEX_DH_GEX_REPLY
The server will log the incoming connection and then after a few minutes prints "Timeout before authentication".
I already tried "Ciphers none" and "MACs hmac-md5-96" and also SSH protocol version 1 without much success. xx(
Any other hints?
Regards
Steffen