chikorita157
Well-known member
I finally got the rare G4 ZIF upgrade from PowerLogix. It wouldn't boot up after installing it despite having the G4 enabler patch installed, so I installed the patch again with the G3 and put the G4 back in.The same thing, until I turned the dial to the correct setting. Had to look at the manual.



Now it's fully working after adjusting the dial and installing the necessary software. I noticed that on Mac OS X, it was performing poorly without the software. Installing MACh Speed Control fixed that and it runs properly now.


I only ran XBench with the G4, but it scores practically this.
Comparing with the results from LEM
10.2.8 10.3.9 10.4.11
Overall 33.4 10.8 11.9
CPU 21.8 9.9 9.6
Threads 25.8 15.0 14.8
Memory 22.4 6.5 6.5
Quartz 39.6 15.9 16.1
OpenGL 49.7 26.4 28.1
User Int. 47.2 5.0 7.0
Drive 72.6 47.5 45.7



Now it's fully working after adjusting the dial and installing the necessary software. I noticed that on Mac OS X, it was performing poorly without the software. Installing MACh Speed Control fixed that and it runs properly now.


I only ran XBench with the G4, but it scores practically this.

Comparing with the results from LEM
10.2.8 10.3.9 10.4.11
Overall 33.4 10.8 11.9
CPU 21.8 9.9 9.6
Threads 25.8 15.0 14.8
Memory 22.4 6.5 6.5
Quartz 39.6 15.9 16.1
OpenGL 49.7 26.4 28.1
User Int. 47.2 5.0 7.0
Drive 72.6 47.5 45.7