Search results

Hello, Anyone know about this item: https://www.ebay.com/itm/325059566458 Description: This was a working pull of a Power R video adapter. Unusual and rare item. It plugs into the logic board power supply connector and plug your power supply cable into it. The video cable that comes with...

THx @Bolle I finally got around to getting the stuff on top of the IIci out of the way... I first pulled the Daystar 601 and it booted with video just fine. After reinstalling the 601 it too worked fine.  I didn't have to reseat the Ram.  

Hi all... I fired up my IIci after it had been sitting for a few months with some sporadic video issues.  I reseated the cable that goes through 2 KVMs to my Sun LCD monitor and it fired up and worked fine for about 10 minutes and then failed to this patterns: I rebooted the machine and it...

Nice work on those!

If you remember, could you write it down and share the steps?  I just got Nisus Word Processor 3.06 on disk and I'd like to make backups.  

Yep, that is the one and it has been great except for its locations for hard drives.  There is one in the 3.5" bay and then another towards the top/back of the case.  Since we are in Hacks...here is a mod that I made: This is a bracket that I made to hold 2 drives from some case internals I...

Not sure on the make...the branding is from the PC shop that I got it from circa '98 called Cutting Edge Computers in Redmond WA.

Please count me in as well. I am hoping to get one of my IIfx boards up and running soon.

Oh yeah, that cases is bedazzled with many LEDs: The case came from CompUSA and I think it is a white-labled InWin or KingWin. I added the stainless drawer handles on top to move it around as well as the fan in window to match the stock fan on the top window.  It runs XP on an intel 915GUX...

I think this may qualify as a hack...  At the office I have a workstation that can be used standing or sitting. With the work from home in place, to get a standing workstation I took and old coffee table and sat it on top of my home office desk with monitor arms holding the 2 Tunderbolt...

Very nice work!

Looks very nice! I finally got my SE/30s out and am still working on them...

Subscribed. 

If this happens, please count me in for 2 of these.

So the problem you just fixed was with a Micron Xceed card card have a line on screen when used in conjunction of a grayscale adapter? I have 2 Xceed cards and one of them has the line...

These are the 2 IIsi Daystar adaptors that I have.  Also have the Daystar that allows you to put an accelerator or cache card in the SE/30.

Did anyone try a Carrera 040 in a Daystar adapter to see if it works? I now have a working IIsi and the needed pieces however I am somewhat concerned about possible damage...

OK, i got the Sun setup before the start of the Seahawks game.  Here is my report thus far... My Vintage Macs and PCs will all share this monitor with a dual KVM setup that is: Dr Bott KVM >> NEC multiSync adapter  >> VGA cable into a Belkin SOHO KVM >> VGA cable into the Sun...

So I was at the local thrift store and I saw a nice looking Sun 20.1 LCD monitor sitting there for $9.99.  I didn't know if this LCD support sync on green so I asked if they'd hold it for me until close.  I came back with with my IIsi in a duffle with the needed cable. It fired right up and...

Getting my IIfx and this bit of kit working is high on my list.  Hoping to get to it around the holidays.