• Updated 2023-07-12: Hello, Guest! Welcome back, and be sure to check out this follow-up post about our outage a week or so ago.

Search results

  1. Scribe

    Aluminum PowerBook G4 battery

    The battery in my 12" Aluminum PB G4 doesn't hold a charge for very long. If it is fully charged and running off the battery it lasts about 30 minutes or so before dying. If it's fully charged and totally shut down (unplugged and sitting in a drawer), the battery is drained completely within a...
  2. Scribe

    Is there a way to preserve the network selection (Ethernet) without a PRAM battery?

    Mac SE with Asante Ethernet card, 4 MB RAM, SCSI2SD with partitioned 8GB SD card, System 6.0.8 (also System 7.1 on a different partition, but I try to avoid it because sloooooow). When Mac is unplugged or even just switched off, the network reverts to LocalTalk. Is there any way around this...
  3. Scribe

    Questions about 3D printing a reset/interrupt switch (AKA programmers button) for a Mac SE

    There are 2 versions of the switch on Thingiverse: <https://www.thingiverse.com/thing:2579509> and <https://www.thingiverse.com/thing:4324446>. In the notes, one of them says that it *must* be printed vertically (or the arms that press the internal buttons will be too weak). The other one says...
  4. Scribe

    ISO internal SCSI2SD mount for Mac SE with easy access to the SD card

    Apologies if this has been addressed. I've searched through the posts and didn't find a solution to my particular issue… I am looking for a way to mount a SCSI2SD (v5.1) against the front of an SE so that the SD card can be swapped in and out easily without opening the case. Most of the...
Top