Hi All,
I've placed a Mac mini into a Mac SE/30 case and then installed a 9.7" iPad screen with driver board to create a cool little Mac unit. I plan on running a Classic Mac emulator on this unit.
One issue I have is that the screen size is bigger than the size of the Mac SE/30 front panel...
Hi All,
I have picked up a MicroMac card per attached picture. Note that it apparently came from a Mac Classic but I believe it's supposed to work in a Mac SE as well. I had to purchase a new PDS slot connector and will solder in the next few days.
I of course made the assumption that if I...
Hi All,
I have a Mac SE that both the motherboard and analog board have been recapped. The machine powers on and I get the familiar boing. Fans spin up but screen remains blank. Is this just likely a replacement of the two 470k ohm resistors R22 and R25?
Thanks
Sonny
Hi All,
I recently picked up a SuperMac accelerator card for a Mac SE. I think the card is a 16 MHz 68000 accelerator. I’ve added some photos to show what I’ve got.
Does anyone have the drivers for this card or know where I could get the drivers?
Thanks
macsonny
Hi All,
I have a Mac SE that I'm in the process of restoring.
On powerup, I get no chime but an error message 0000000E/00000100" displayed and some lines on the scrren per attached screen shot.
Any ideas on what's happening?
Thanks
Sonny
Hey All,
I'm in the process of restoring a Mac SE. So far so good. I have found a strange issue though. The L1 inductor on the analog board that's used to tune the horizontal picture alignment is missing the screw inside the long cylinder. An odd one know.
I've moved a long screw driver inside...
Hi All,
I have a Mac SE/30 that I picked up. Started up fine a few times but after about a week it started up with a blank screen and a bright horizontal line. Also not boot noise on power up.
So, based on lots of advice I have recapped BOTH the analog board and the motherboard.
Now when i...