• Hello, Guest! Welcome back, and be sure to check out this post for more info about the recent service interruption and migration.

Recent content by GaiusIuliusCaesar

  1. GaiusIuliusCaesar

    Designing RaSCSI case for CM4 IO board and OLED questions

    Ok got the OLED attached via jumpers and it kinda works. Set height to 64 in the script and still gives mostly grabbled display any ideas from anyone here on what is going on?
  2. GaiusIuliusCaesar

    Designing RaSCSI case for CM4 IO board and OLED questions

    I actually don't know much really, just saw that the NVMe storage worked with the I/O board and the firmware had been updated to allow booting from it. Also read that for read/write speed that PCIe 1x > USB3.0 > emmc > microSD. As for routing PCI over pci express that is way out my league. It...
  3. GaiusIuliusCaesar

    Designing RaSCSI case for CM4 IO board and OLED questions

    I am working on getting a RaSCSI setup for using the Raspberry PI Compute Module 4. I have the I/O board and 1GB ram CM4 Lite(no onboard EMMC). I wanted to use a 2GB or 4GB version but they are out of stock at work due to chip shortage(I am a repair tech at Microcenter). Anyway, the whole...
  4. GaiusIuliusCaesar

    Centris 650 heatsink clip dimensions, looking to model replacement to 3d print

    Actually both, I was planning on moving the heavier heatsink from a Centris 650 to a Quadra 650 with the other heatsink. I was examining also looking at using this. I was asking because even using caliper I always screw something out. You should have seen how many revsions it took me to...
  5. GaiusIuliusCaesar

    Centris 650 heatsink clip dimensions, looking to model replacement to 3d print

    I am looking for the dimensions for the bracket that holds the heatsink for a Centris 650. It is label 830-0115. I want to model and 3d print a replacement that includes a small fan mount. Googling that number didn't help. I plan to use Polycarbonate(PC) for printing so should hold up to the...
Top