Recent content by Cubbie036

FYI - They are the same. I have a Sharp Cable going to my Toshiba display on my PowerBook 540c PPC. Oh and my screen is glossy and a Toshiba.

I remember back in the old days using a long bar magnet across the display to fix that sort of thing.

Do you happen to have the Extreme Systems software installer or can you upload the control panel and any extension here. ALL the copies of the software on MacintoshRepo, MacGarden, etc are corrupt. I cannot find them anywhere. I have the same accelerator but no software. I'm begging you to...

Any one have the aforementioned Software? Every site I download it from seems to be same corrupt .sit file that can't be uncompressed.

Check that all your new caps on the analog board are properly soldered and facing the correct direct Would be where I‘d start first.

The Macintosh TV issue was that, though I fit in the CC, the Analog Video board was not powerful enough to provide power to everything. I popped it into a the Performa 550 and booted up perfectly. 

I have repaired 3 CC Logic Boards, 1 Macintosh TV LB, and 1 LC 520 & 1 Performa 550 LB. I used clippers to clip the old caps off the boards. Clipping at the center of the Cap. I then used a flathead screwdriver to carefully remove the bottom portion of the caps. I left the metal poz &amp...

Bump on Schematics? 

Okay I wash the boards in the dishwasher. Still no boot sound on the CC logic board and the Macintosh TV Board still doesn’t see the hard drive. Anyone know where I can get schematics?

I think the dishwasher is on must run out I’ll just make sure to wait until it has and then run it through.

Okay. Will do that! Will jetdry cause an issue? I know you do it without detergent 

I used  I saprobic alcohol 99% to clean the board and when I put it into my color classic it had a distorted video but it and boot it now I get this started video still but no hard drive is found. I’ve heard people running it through the dishwasher 

What changes need to be done to the motherboard? Sorry if I'm getting confused. I know I have to cut down the AB from the 550 to fit in the smaller CC case. On a side note does anyone have access to the schematics for the CC and Macintosh TV logic boards? I recapped the Mac TV board and...

Are you talking about the physical modification because it’s too wide or additional modifications to the actual circuitry? I get that it is too wide. 

Oh... very cool!!! Thank you. I just recapped my Macintosh TV Logic Board and put it in a CC and I get video, though massively distorted. Need to create a new boot disk that the Mac TV will work on. I will have to go pull the AB from the 550 and see were it lands me!!  Thanks again!