Jump to content
Sign in to follow this  
bibilit

screen geometry default CC

Recommended Posts

My Classic Color has been repaired a couple of times, new caps in the Logic Board, new caps in the Analog Board (plus a lot of soldering here and there)

 

This morning i adjusted the screen and the result is not too bad, screen is sharp and colors are good, but the left side is not straight (right is far better, not perfect)

 

adjusting the pot can not give me the result i am looking for, any idea ?

 

post-1736-0-65347500-1510405017_thumb.jpg

 

 

Share this post


Link to post
Share on other sites

Your picture looks to be too tall and too wide.

See if reducing the width also reduces the barrel effect (it should do so)

Then adjust the height to match the width you set. If the height can not be reduced your B+ might be a little bit too high, which happens sometimes after recapping.

 

Did you measure the pots if resistance changes at all when turned?

Edited by Bolle

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×