Latest activity
-
demik replied to the thread SCSI Printers: LaserWriter II SC or Personal LaserWriter SC.Just as a note if other people end up there: You cannot select a IIsc or Personal LaserWriter SC in the chooser list (on the right... -
CCC_333 replied to the thread Beige G3 RAM and PSU questions:.Indeed! But, @croissantking discovered how to get the beige G3's unimplemented USB circuits working, so this couldn't be that hard...
-
Durosity replied to the thread Beige G3 RAM and PSU questions:.Well that’s a bummer! And quick work.. I was gonna go try that out tomorrow when I get back from Glasgow, but you beat me to the punch 😅 -
Phipli replied to the thread Beige G3 RAM and PSU questions:.They planned to move to PC floppy drives to reduce costs, but ended up not doing it on the G3 (perhaps because it didn't work). In the... -
Trianon replied to the thread Beige G3 RAM and PSU questions:.I'm also working on a beige G3 these days and was wondering about this connector : - there are to bays in the top plastic for an FDD... -
Scott Baret replied to the thread Plus - Partial Power?.In this case it may be what wasn't done given that this computer has essentially sat for 35 years. I'm also not sure what kind of... -
Callan replied to the thread Plus - Partial Power?.I'd look it over first. It might be as simple as a bad solder joint. Also visually check everything before replacing the analog ( the... -
Yymk replied to the thread Looking for some SE/30 repair direction.Looks like a problem in a video address line. I'd start with the shotgun approach of cleaning up and reflowing the whole row of video...
-
CChopsticks replied to the thread Smoke out of the SE/30 Video ROM.@superjer2000 i probably shouldn't have used the phrase "clear indicator" when i posted above, might have been better if i said it was...
-
Scott Baret replied to the thread Plus - Partial Power?.I do have a functional spare analog board...should I try that first just to see if it springs to life?
-
Callan replied to the thread Looking for some SE/30 repair direction.I'd check the logic / traces above C7. If the board wasn't cleaned properly after the cap kit the leaked electrolyte continues to do...
-
SSpocksBeer replied to the thread Mac SE/30 high voltage on 30v rail.It lives....again! Turns out the fault was with the C13 cap, near the flyback. Completely dried out/not capacitoring. It's meant to...
-
-
Callan replied to the thread Plus - Partial Power?.Sounds like your not getting 5v. Your going to have to check your solder joints on the power connector before you can asses what...
-
Byrd replied to the thread Plus - Partial Power?.First up I'd take off the lid and keep tapping the analogue board around the usual dry solder zones, it might spring to life all of a...
