I just finished installing a SCSI2SD in my finally repaired SE FDHD. I have the SCSI2SD set up as one SCSI ID (0), and have the drive partitioned into two drives. I installed 6.0.8 on one drive, and 7.1 on the other. I ran the machine off 7.1, no issue. Then I used Startup Disk to designate the other partition as the startup drive. Started up in 6.0.8 no problem. Now, however, I can't seem to get back to 7.1. System folder is blessed, and I use the Startup Disk INIT in the Control Panel to designate the 7.1 disk, but it always restarts in 6.0.8. Of interest, when I do use Startup Disk, both drives are highlighted by default. I have to click elsewhere, then click the 7.1 partition to have it highlighted only. Am I doing something wrong here? I'll admit, I have no experience with dual boot between Systems 6 and 7.
