SE/30 - SCSI and Floppy Not Working

[ccbruegge10]

Hey there,

I've had a random, sudden issue with my Macintosh SE/30. The SCSI bus and Floppy bus don't seem to be working properly. I've been using a BlueSCSI in place of a hard drive for a while and everything was working perfectly. I took the BlueSCSI out to update the firmware and when I tried to boot from it, the BlueSCSI wasn't getting any power. Powering it with the Molex connector works. I tried another BlueSCSI and same issue. Further, I also noticed that the floppy drive doesn't work anymore either. I tried my FloppyEmu and the Emu gets power and I can choose a disk to load, but selected a disk does nothing. I'm not sure what could have happened. I checked the logic board and it looks fine.

Can anyone tell me if they've encountered this problem?

 

[Durosity]

I'm gonna make an educated guess that it's something in the SWIM controller as that's the only thing on the schematic that I can see that connects to both of them... either that or one of the voltage rails has gone perhaps? Have you probed it with a multimeter?

 

[robin-fo]

Did you recap the logic board?